30000 plantsA should be considered the minimum plant population for achieving optimal yields

30,000 plants/A should be considered the minimum plant population for achieving optimal yields.

Can 30,000 cotton plants per acre be enough to reach top yield?

Plant populations are not the same as seeding rates.

The optimal seeding rate and plant population for cotton varies from field to field and is dependent on many factors.  As seed costs are considerable, there is an incentive to reduce seeding rates as low as possible without encountering yield penalties.

In recent years, several growers have inquired if plant populations as low as 30,000 plants per acre are sufficient for optimal yields. Recent research in Dr. Keith Edmisten’s program has suggested that this plant population may be sufficient if certain conditions are met and if plants are evenly distributed. It is important to note that:

  1. Plant populations are not the same as seeding rates. Generally speaking, for 36-inch rows, growers should be planting a minimum seeding rate of around 36,300 seed/A (2.5 seed/foot of row, or 2 seed every 9.6 inches hilldropped) in order to expect a final plant population of 30,000 plants/A.
  2. 30,000 plants/A should be considered the minimum plant population for achieving optimal yields.  The lowest recommended seeding rates mentioned in (1.) above should only be planted when conditions are excellent (i.e., when planting high vigor seed into warm soils with adequate moisture, and when conditions following planting are expected to support good stand establishment).  Seeding rates should be adjusted (increased) if planting conditions are less than excellent.

The table illustrates various seeding rates per acre and the correlating number of seed per foot of row and hill spacing for hilldropping 2 seed for various rows spacings.  Note that the lowest recommended “per acre” seeding rate for achieving 30,000 plants per acre is 36,300.  Growers should increase seeding rates above that, if any of the following conditions are expected:

  • Cool, wet soils: This is most likely to occur when planting in late April or early May and could result in less than optimal plant stands and slow seedling emergence.  If soil temperatures in the planting zone are less than 60 to 65ºF by mid-morning or if less than 50 DD-60’s are expected within 5 days of planting into moist soils, then seeding rates should be increased.  Cotton seed are very sensitive to cool temperatures within the first 2-3 days after planting
  • Crusting: growers should consider hilldropping if crusting is expected.  Planting high vigor and larger seed could improve stand establishment in these situations
  • Poor soil/seed contact or poor seed coverage: cotton should be planted between ½ and ¾ inches deep and planted into warm soils with good moisture.  However, less than optimal stands can be expected if the furrow isn’t adequately covered.
  • Late planting: Although conditions are generally favorable for rapid seedling emergence during late May, seeding rates may need to be increased in order to avoid late maturity and to avoid reliance on outer position or vegetative bolls as major contributors to the final yield.

It is important to realize that all seed are not equal and all planting conditions are not equal.  Using cool germination figures and planting conditions to adjust seeding rates can help avoid replanting in some situations. Consider increasing seeding rates when conditions and/or cool germ percentages are marginal. Obtaining cool germination information for each seed lot a grower purchases can also avoid using lower cool germ seed lots in marginal conditions.

Read more about this and other cotton production information at NC State University blog.

TAGS: Planting
Hide comments

Comments

  • Allowed HTML tags: <em> <strong> <blockquote> <br> <p>

Plain text

  • No HTML tags allowed.
  • Web page addresses and e-mail addresses turn into links automatically.
  • Lines and paragraphs break automatically.
Publish